On this page
  1. What does a periodontal chart record?
  2. What does the six-site layout look like?
  3. What is the difference between full mouth and six-point charting?
  4. How is clinical attachment level calculated?
  5. How are bleeding, mobility and furcation recorded?
  6. What is BPE or PSR screening?
  7. What makes readings consistent?
  8. What do you compare between visits?
  9. Where does the chart stop?
Clinical cover for Periodontal charting: recording readings that compare
Quick answer

Periodontal charting records probing depth, recession, bleeding, mobility and furcation tooth by tooth. A full mouth chart takes six readings per tooth: three on the buccal and three on the lingual. Clinical attachment level comes from the probing depth and the position of the gum margin. Consistency between visits matters more than any single number.

A periodontal chart is only as good as the next chart beside it. One number tells you a pocket is 6 mm deep. Two numbers, taken a year apart with the same method, tell you whether it changed.

The readings matter less than the consistency of how they were taken and recorded. A clinic that charts six sites on one visit, four on the next and a screening score on the third has three documents that cannot be compared.

What does a periodontal chart record?

Six things, per tooth:

  • Probing depth at each site.
  • The position of the gum margin, which gives recession or overgrowth.
  • Bleeding on probing.
  • Mobility.
  • Furcation involvement, where the roots divide.
  • Plaque or calculus, if the practice records it.

Some charts add suppuration, gingival colour, and the width of attached gingiva. Add them only if the team will record them consistently. An empty column is more honest than a column filled at random.

The chart is a record of measurements. The diagnosis and the treatment plan are separate documents, and the clinical decision stays with the dentist. The tooth-level chart sits beside it, and the notation is covered in our guide to what an odontogram records.

What does the six-site layout look like?

For each tooth, three readings on the buccal aspect and three on the lingual or palatal aspect.

Swipe the table to see every column
Tooth DB B MB DL L ML
16 3 2 3 3 2 3
15 2 2 3 3 2 2
14 3 2 2 3 3 2
13 2 2 2 2 2 2

DB is distobuccal, B is buccal, MB is mesiobuccal. DL, L and ML are the same three sites on the lingual side.

Two ordering conventions are common. One runs distal to mesial on both sides, which is the layout above. The other runs mesial to distal on the buccal and distal to mesial on the lingual, so the numbers read around the tooth in one direction. Software may fix one order, and a good charting module will show you which one it uses before you enter the first patient. The rule is to know which one your chart uses and to keep it for every patient.

Recession needs its own row, or a paired value in the same cell. A chart that records only the pocket depth cannot tell a 5 mm pocket with a healthy margin from a 5 mm pocket with 3 mm of recession. The second has lost attachment, and the two look identical without the margin position.

What is the difference between full mouth and six-point charting?

Full mouth charting means every tooth, every site, at a planned visit. Six-point refers to the number of sites per tooth. In practice clinics use the terms loosely.

The useful distinction is when the chart is taken, not how many sites it holds:

  • A full chart at the first periodontal assessment, and at planned intervals after that.
  • A section chart for a patient with a localised problem, where only the affected teeth are recorded.
  • A screening score at every new patient examination, to decide who needs the full chart.

A section chart is fine as long as it says so. The record should name which teeth were charted and which were not, otherwise a reader assumes the missing teeth were healthy.

How is clinical attachment level calculated?

Attachment level is measured from the cementoenamel junction, the fixed line at the neck of the tooth. Probing depth is measured from the gum margin. When the gum has receded, the two numbers differ.

A pocket of 4 mm with 2 mm of recession means the attachment is 6 mm from the enamel junction. The same 4 mm pocket with the gum margin above the junction has a different attachment level. This is why the chart needs both numbers, and why a chart that stores only probing depth is a partial record.

Some software calculates attachment level automatically from the depth and margin. Check that it uses the right direction for a margin that sits above the junction, because a negative recession value entered as positive turns a gain into a loss.

How are bleeding, mobility and furcation recorded?

Bleeding on probing is recorded per site, immediately after the probe is withdrawn and before the patient rinses. A simple yes or no per site is enough; a score from 0 to 3 invites disagreement between clinicians.

Mobility is recorded per tooth on the Miller scale, from 0 to 3, with the tooth held between two instruments. Record the grade, and note if a neighbouring tooth moves with it, because the grade depends on that.

Furcation is recorded per tooth by grade, and by which surface is involved: buccal, lingual, mesial or distal. A molar with a buccal furcation and a molar with a mesial furcation are different records, even at the same grade.

What is BPE or PSR screening?

The Basic Periodontal Examination, used in the UK and several other countries, divides the mouth into six sextants and gives each a score from 0 to 4. An asterisk marks a furcation. The similar PSR, used in the United States, works on the same idea.

The score is the worst site in the sextant. Code 0 means no pocket and no bleeding. Codes 1 and 2 mean the pocket is shallow but bleeding or calculus is present. Codes 3 and 4 mean the pocket is deeper, with 4 losing the probe marking. The dentist decides what follows a 3 or a 4. A screening tool flags; it does not diagnose.

Screening is worth doing at a new patient examination because it takes a minute and tells you whether a full chart is needed. Keep the score in a separate field from the six-site chart. Mixing a sextant score into a per-site table produces a record nobody can read.

What makes readings consistent?

Ten habits, most of them about method rather than skill.

  1. Use the same probe type across the practice, and check the markings are still visible.
  2. Probe with light force, walking around each tooth.
  3. Record six sites in the same order at every visit.
  4. Record the gum margin as well as the depth.
  5. Record bleeding before the patient rinses.
  6. Chart at the visit, not from memory at the end of the day.
  7. Note third molars and implants, which are often left out or probed differently.
  8. Mark a tooth as missing rather than leaving blank cells.
  9. Write "not recorded" when a site was not probed, instead of zero.
  10. Sign and date the chart, and keep every version.

Item nine is the one that causes quiet errors. A zero means a healthy site. A blank means nobody looked. A software chart that fills blanks with zero has changed the record.

What do you compare between visits?

Compare the same site on the same tooth, and compare attachment level rather than depth alone.

Three questions are worth asking of any two charts:

  • Did any site get deeper by 2 mm or more?
  • Did attachment level change at the same site?
  • Did bleeding at a site stop, start or stay the same?

Everything else is detail. A chart that answers those three questions supports a conversation about whether the patient is stable, and a chart that cannot answer them is a set of numbers with no story.

Recording the trend needs structured data, not a photo of a printout. If the software can graph a single site across five visits, the change is visible in a way that a table of numbers is not. Our guide to digital dental charting covers how that fits with the rest of the record.

Where does the chart stop?

A periodontal chart records what the probe found on the day. It does not record why, and it cannot decide what to do.

Two clinicians can probe the same patient and differ by a millimetre at several sites. That is normal, and it is why the same clinician charting over time is more useful than a perfect single reading. The record should say who charted it.

The clinical note carries the context: a site that bled, a patient who mentioned sensitivity, a decision to review in three months. The chart is the measurement, and the dentist makes the call.

Frequently asked questions

How many sites are charted per tooth in periodontal charting?

A full mouth chart records six sites per tooth: distobuccal, buccal and mesiobuccal on the outside, and distolingual, lingual and mesiolingual on the inside. Some practices use four sites or three. Whatever the number, keep the same sites and the same order at every visit, or the readings cannot be compared.

What is the difference between probing depth and clinical attachment level?

Probing depth measures from the gum margin to the bottom of the pocket. Attachment level measures from the cementoenamel junction, which does not move, so it shows what has been lost. A chart that records only probing depth can miss recession. Record the gum margin position as well, and the attachment level follows.

Is a BPE score the same as a periodontal chart?

No. A Basic Periodontal Examination divides the mouth into sextants and gives each a score from 0 to 4, with an asterisk for furcation. It is a screening tool, quick enough for every new patient. A full chart records each site. A BPE score cannot be compared with a six-point chart, so keep the two separate in the record.

Should bleeding on probing be recorded at every visit?

Yes, if you are charting the patient at all. Bleeding is recorded per site right after probing, before the mouth is rinsed, because that is when it is visible. A chart that records depths but not bleeding loses the part that shows whether the gums are stable between visits.

How long should a periodontal chart be kept?

Keep it as long as the clinical record, which is a decision for the clinic's written retention policy. Charts from five years ago are still useful when a patient returns or moves to another dentist, because they show change over time. Store each version rather than overwriting the last one.

See it with your own clinic day.

Book a walkthrough and follow a patient from booking through charting, treatment and billing. No patient data is needed.